Komelon Gripper Pro tape measure: check where the reading starts

If you use a tape to size both a shelf and the space it goes into, the end hook meets the work in two different ways. It catches an outside edge on the shelf. It can rest against a face when you measure from inside an opening. Check how the hook is designed to work before you buy a replacement tape, especially if a reading from one face will be used to order a part that fits between two others.

Decide which faces define the measurement

Write the start and end faces down before taking a reading. For a shelf, the start might be the outside edge and the end the opposite outside edge. For the cupboard opening, name the two finished inside faces. If the opening is between walls or panels, note where along the opening you measured. A skirting board, trim strip or bowed panel can make the available space different at the front and back.

Keep the readings labelled on the order note. For example, “shelf outside edge to outside edge, millimetres” and “opening inside face to inside face, front and back, millimetres” are separate measurements. Record the unit printed on the scale you read. Check with the supplier or installer about the required fitting clearance before ordering from those numbers.

Check what the hook is designed to do

Komelon describes the Gripper Pro’s True Zero end hook as movable for inside and outside measurements. When it catches an outer edge, the hook moves outward. When its end is pushed against a face, it moves inward. That movement is part of the design. A bent hook, worn blade or inconsistent reading still needs checking. The moving hook also deals with the starting face only. If the tape case is in the way at the far end, use a suitable method for that end and record where the reading finishes.

Match the full reference when ordering

Komelon’s catalogue row for KG-8025 lists an 8 m/26 ft tape with a 25 mm blade and unit barcode 8803005001957. The manufacturer describes the family blade as marked in metric and imperial units and rated Class II. If a calibration requirement applies to your work, check the actual tool and your procedure before relying on a catalogue classification. Two listings with a similar name and the same nominal length can still have different identifiers. Compare the full model and barcode if you need this exact version.

Buy now: Komelon KG-8025 Gripper Pro 8 m/26 ft tape measure

Komelon Gripper Pro manufacturer specification and model table