A waste fitting can miss a cupboard drawer when it is open and still obstruct it when it closes. Before buying a space-saving inlet, trace the whole proposed waste route: from the underside of the sink, past the storage area, through the trap and on towards the waste outlet. The part nearest the bowl is only one part of that route.
The McAlpine SSINLET1 is a nominal 1½-inch Space Saver Trap Inlet. McAlpine describes it as a way to make better use of the space below the sink bowl. Its offset form makes it worth considering when a conventional drop from the bowl would occupy the area you want for storage. Whether it solves your cupboard problem depends on where the rest of the arrangement can go.

Identify the obstruction before choosing the part
If the problem is the space directly below the bowl, an offset inlet is relevant to the layout discussion. If the obstruction is farther along—at the proposed trap, a shelf or the cabinet’s waste exit—the inlet alone may not address it. Mark the area that must stay clear before deciding which component to order.
For example, a drawer could clear the straight part of a proposed run but strike its end bend. A layout check that records only the gap beneath the bowl would miss that conflict. Show the drawer’s closed position and its travel, rather than drawing the pipe route over a photograph taken with the drawer removed.
Check three parts of the proposed route
- At the bowl: identify the existing sink-waste connection and the space around it. The nominal 1½-inch description identifies the selected SSINLET1 model; it does not confirm that an unidentified existing connection will mate with it.
- Across the cupboard: show the route’s occupied space, including its end bends and joints. Compare it with shelves, drawer movement and other services, not just the empty centre of the cabinet.
- At the trap and outlet: ask the installer to mark where those parts will sit and how they will remain accessible. Moving the inlet away from the bowl is useful only if the resulting arrangement still works as a whole.
A simple cupboard sketch is enough to start that conversation. Put the sink-waste position, cabinet back, intended storage area and proposed trap position on the same sketch. Add measurements from the actual cupboard where they are known; do not obtain a reach or adjustment range by scaling the product photograph. Any uncertain connection or clearance needs checking against the exact component information before the layout is agreed.
An inlet component is not a complete trap order
Put SSINLET1 on the parts list as the inlet component. Do not use that line to check off a complete trap kit, sink-waste outlet or every connecting piece needed for the arrangement. The inlet, the trap and the onward connection have different jobs, even when they are close together in the finished cupboard.
Confirm the current supplied contents if a particular nut, seal or other piece is essential to completing your order. McAlpine’s catalogue reference establishes the nominal component; APM’s photograph does not establish every part in a supplied pack. For this purchase, the useful result is an identified inlet on a layout that leaves the intended storage space clear—not a promise based on the words “space saver”.
Buy now: McAlpine SSINLET1 1½-inch Space Saver Trap Inlet at APM
Model and purpose: McAlpine Space Saver Trap Inlet product information, selected model SSINLET1. The layout checks above are buying guidance, not fitting instructions.
Leave a comment