Skip to content
Natural-coloured Q-Crimp cable-tie cradle with two raised side openings and a central recessed round hole.

Q-Crimp QTC cradle: the fixing hole is not the cable-tie width

The number beside “cable-tie cradle” needs its label. A fixing-hole dimension and a cable-tie width describe different parts of the purchase. Reading one as the other can leave you comparing the wrong measurements, even when the accessory looks familiar.

For the natural Q-Crimp QTC cradle, Unicrimp’s product page uses a 4.9 mm diameter-hole heading. Its QTC technical sheet, dated 22 September 2026, separately lists a 5 mm fixing diameter and a 9 mm maximum cable-tie width. Keep those descriptions attached to their numbers.

What each published number answers

Reference Maker’s description Buying consequence
4.9 mm Diameter-hole wording in the product heading A fixing reference, not the maximum tie width.
5 mm Fixing diameter in the technical sheet Not a measured clearance or a promise that an existing fixing will suit.
9 mm Maximum cable-tie width in the technical sheet A separate width limit, not the fixing-hole diameter or a load rating.

The 4.9 mm and 5 mm figures are two published fixing references for QTC. They are not measurements taken from APM stock, a tolerance calculation or proof that the part is different. Do not average them or use either as the cable-tie width. If an exact fixing clearance matters, obtain the applicable current fixing data rather than treating catalogue naming as a measurement.

Natural-coloured Q-Crimp cradle with a central recessed round hole and two raised side openings in the APM listing photograph.
The central hole and raised openings are visibly separate features. This listing photograph has no measuring scale and does not establish the supplied pack or included fixings.

Compare the tie requirement with the width limit

Suppose your requirement specifies a 10 mm wide tie. That exceeds the maker’s stated 9 mm maximum for this cradle. The 4.9 mm label does not change the comparison, because it describes a different feature. A photograph that makes the openings look generous is not a substitute for the published limit.

An 8 mm wide tie is below that nominal width limit. That is one useful comparison, but it does not by itself approve the tie, fixing or complete arrangement for a particular duty. Width is a purchasing parameter; it is not evidence of load capacity, suitability for a surface or resistance to the conditions where the assembly will be used.

Check the fixing requirement independently

Now reverse the question. A request for a particular fixing does not tell you which tie width is needed. Equally, choosing a tie below the width limit does not settle the fixing choice. Keep both requirements visible when comparing the part, rather than writing a single “size” against the whole assembly.

This is especially useful when replacing an existing accessory. A similar shape can help identify the type of part, but it does not establish matching dimensions or permission to reuse an existing fixing. Use the exact model reference and applicable fixing information. This guide does not specify a substrate, fastener or mounting method.

Buy the cradle as a defined component

The APM photograph shows the cradle, not a completed cable bundle. It does not establish that ties or fixing hardware accompany the item. Confirm the sale quantity and included parts separately if they are important to the order; a nominal manufacturer reference is not a physical count of the pack you will receive.

The useful decision is therefore a pair of comparisons: the specified tie width against the maker’s width limit, and the fixing requirement against the applicable fixing data. Keeping those roles separate is more useful than choosing whichever number appears most prominently in a product title.

Buy now: Q-Crimp natural cable-tie cradle with 4.9 mm hole listing.

Previous article Buying a caulking gun: what does “up to 380ml” actually tell you?
Next article Choosing a Towel Ring: Check Towel Drop and Hand Space

Leave a comment

* Required fields

Compare products

{"one"=>"Select 2 or 3 items to compare", "other"=>"{{ count }} of 3 items selected"}

Select first item to compare

Select second item to compare

Select third item to compare

Compare